$Id: tool_table.txt,v 1.6 2017/01/29 16:27:38 protius Exp $


1	OD thread tool  (from Mike)
2	cut ID towards chuck   small radius   tool is about 1" dia
3	cut OD away from chuck  large radius nose, about 1.25 in back from face of turret 
	broken insert, don't use
4	cut ID, square 0.06 wide 1/2 in diameter max depth 1.5
5	cut OD away from chuck large radius nose, abut 1.25 in back from face of turret
6	empty
7	cutoff  max depth abut 3/4 in  abut 1/4 in infront of turret face
8	drill chuck  (from Mike)
9	outside towards chuck   small radius nose
10	empty
11	cut OD towards chuck larger radius nose  1/32?
12	empty


With the concave jaws, do not pass:
2	Z=2.12 
4
5	Z=3.42
8	depends on drill
11	Z=2.05


With the pointy jaws, do not pass:
2	2.210
4
5	3.500
8	depends on drill
11	2.170



Using my 1/2 inch drill, all the way back into the chuck, the tool
offset is: +0.2242 +7.3166

5mm drill, tip of flute to tip of jaw, tool offset= +0.2242 +5.1306